• Papermaking STOCK PREPARATION– LC REFINING

    To evaluate pulp in the laboratory, it must be first beaten or refined, as is the case in industrial papermaking. Several types of laboratory refiners exist for this purpose The mos common is he PFI m lli The PFI mill,shown schematically, is by far the most common laboratory refiner in use today. However, its action differs substantially from

    Get price
  • Pulp Refiner (PFI type) - PNSHAR

    Pulp Refiner (PFI type) 1. Introduction: It is used in the pulping and paper-making industry, for the paper pulp buckle determination, the paper pulp test specimen moisture content's determination, the paper pulp density's determination, the wet degree of dissociation's determination, the degree of ionization

    Get price
  • The influence of refining heterogeneity on paper ...

    Decker (2005) reported that only 7 to 20% of the fibers are treated in an industrial disc refiner. On a laboratory scale, the pulp is usually treated by multiple passages. Particular PFI-refining is believed to treat the pulps homogenously (Dillén 1980; Lidbrandt and Mohlin 1980).

    Get price
  • Refining of fibres at laboratory scale

    Laboratory Testing Refining of fibres at laboratory scale Refining of fibres at laboratory scale Mechanically converting the fibres to improve the paper properties To evaluate the potential for developing the mechanical properties of lignocellulosic fibres by doing a refining curve ... To produce a batch of refined pulp (chemical or mechanical ...

    Get price
  • Products | IDM Test

    Laboratory equipment for testing and quality control . ... IDM AUTOMATIC PFI TYPE LABORATORY MILL. ... READ MORE. PILES VALEY TYPE REFILLER (DUTCH PILE) PTA. Traditional Dutch pile type laboratory refiner. Used to refine a significant amount of paste/pulp 360 grams. READ MORE. PTA (8 INCH - 200MM) LABORATORY DISK REFINER.

    Get price
  • Impact of pulp consistency on refining process conducted ...

    Changes of bulk vs. refining energy consumption for constant SEC SP value (7.4 kWh/t) and constant pulp consistency. Since tests of the refining process that were carried out with constant SEL value and with variable refiner pulp consistency showed inconsistent results for this parameter, it was decided to examine if SEC SP will be a more ...

    Get price
  • ANDRITZ Inc, Paperchine Springfield, MA, USA

    Corrosion testing; Pulp bleaching (EC, ECF, TCF) Pulp physical properties. Fiber size/morphology; Strength testing (PFI beating) Brightness and opacity; Drainage and freeness; Shive analysis (Pulmac, Somerville, and Valley screens) Biomass pretreatment. Steam explosion (batch-type) Liquid/solid separation; Acid or alkaline hydrolysis; 1- or 2 ...

    Get price
  • Fractionated treatment and separate refining of pulp to ...

    Nov 23, 2015· Fractionation and separate refining Types of refiners • Lab scale Jokro mill PFI Mill Valley Beater • Industrial refiner (e.g) Voith Sulzer Twinflo E 17.11.2015 Rafael Giner Tovar 8 (PFI Mill, Frank-PTI) (Valley Beater, Frank-PTI) (Jokro Mill, Frank-PTI) 9.

    Get price
  • Laboratory BEATER "PFI" type NPFI-02 model

    Laboratory BEATER "PFI" type NPFI-02 model DESCRIPTION The cylindrical container turns at 720 +/- 20 r.p.m and the beater roll with 33 bars at 1440 +/- 30 r.p.m both in the same direction. The beater roll is pressed against the container wall with 3,33 N/mm of bar length. The pulp is beaten due to the pressure between the wall and the bars.

    Get price
  • Impact of pulp consistency on refining process conducted ...

    Changes of bulk vs. refining energy consumption for constant SEC SP value (7.4 kWh/t) and constant pulp consistency. Since tests of the refining process that were carried out with constant SEL value and with variable refiner pulp consistency showed inconsistent results for this parameter, it was decided to examine if SEC SP will be a more ...

    Get price
  • Papermaking STOCK PREPARATION– LC REFINING

    To evaluate pulp in the laboratory, it must be first beaten or refined, as is the case in industrial papermaking. Several types of laboratory refiners exist for this purpose The mos common is he PFI m lli The PFI mill,shown schematically, is by far the most common laboratory refiner in use today. However, its action differs substantially from

    Get price
  • MULTIVARIATE STATISTICAL EVALUATION OF PHYSICAL .

    The PFI mill is the most widely used laboratory scale refiner. Many are the studies based on this type of refiner. Examples are: Leatham and Myers (1990) and Formento et al. (2001). At first, the development of the PFI mill was considered a great improvement over the previous existing laboratory scale

    Get price
  • Fractionated treatment and separate refining of pulp to ...

    Nov 23, 2015· Fractionation and separate refining Types of refiners • Lab scale Jokro mill PFI Mill Valley Beater • Industrial refiner (e.g) Voith Sulzer Twinflo E 17.11.2015 Rafael Giner Tovar 8 (PFI Mill, Frank-PTI) (Valley Beater, Frank-PTI) (Jokro Mill, Frank-PTI) 9.

    Get price
  • Pulp Testing Instruments - Wet Strength Tester ...

    Manufacturer of Pulp Testing Instruments - Wet Strength Tester, Fibre Classifier, Paper Testing Laboratory Beater and SS Lab Valley Beater offered by Universal Engineering Corporation, Saharanpur, Uttar Pradesh. ... LAB DISC REFINER ... LABORATORY BEATER (PFI MILL TYPE) The Lab Beater is used for beating pulp and as a defibration unit for ...

    Get price
  • Pulp Refiner (PFI type) - PNSHAR

    Pulp Refiner (PFI type) 1. Introduction: It is used in the pulping and paper-making industry, for the paper pulp buckle determination, the paper pulp test specimen moisture content's determination, the paper pulp density's determination, the wet degree of dissociation's determination, the degree of ionization

    Get price
  • Kady mill beating, fiber quality testing offer new ...

    2. FS number response: Commercial refining vs PFI laboratory beating 3. L number response: Commercial refining vs PFI laboratory beating 3 5 7 2 6 8 1 % Change in B number 5 10 15 +5 +10 Pulp B Pulp A Pulp C % Change in FS +15 20 +20 0-5 4 3 5 4 1 2 7 8 6 % Change in B number 5 10 15 +5 +10 Pulp A Pulp B % Change in L Pulp C +15 20 +20 0-5

    Get price
  • ISO 5264-2:2011(en), Pulps ? Laboratory beating ? Part 2 ...

    The number of roll revolutions depends on the type of pulp and the beating load. After beating, the drainability is measured according to ISO 5267-1 or ISO 5267-2, and laboratory sheets are prepared according to ISO 5269-1 [1], ISO 5269-2 [2] or ISO 5269-3 [3]. Physical testing of the laboratory sheets is performed according to ISO 5270 [4].

    Get price
  • PULP AND FIBER CHARACTERIZATION OF WHEAT STRAW .

    The effect of PFI refining on the Schopper Riegler The presence of xylan is known to cause distinct swelling of the fiber walls and to facilitate response of the pulp to refining. In Fig. 1 it can also be seen that the response to refining differed between the bleaching sequences, i.e. the SR values of the CEH

    Get price
  • Papermaking STOCK PREPARATION– LC REFINING

    To evaluate pulp in the laboratory, it must be first beaten or refined, as is the case in industrial papermaking. Several types of laboratory refiners exist for this purpose The mos common is he PFI m lli The PFI mill,shown schematically, is by far the most common laboratory refiner in use today. However, its action differs substantially from

    Get price
  • PFI Laboratory Mill | Rycobel

    The refining times vary from 2 to 10 minutes (depending on the type of pulp). After having rotated the preselected revolutions, the roll and the housing stop and the refining process ends. Finally, the roll is situated in the centered initial position and the refined pulp is extracted to measure the freeness of the pulp .

    Get price
  • Pulping Technical Services | Forest Biomaterials | NC ...

    Pulp produced in the pilot plant can be screened, cleaned, washed, and bleached on a continuous basis. Small Pilot-Scale. KRK Pressurized Laboratory Refiner. KRK Pressurized Laboratory Refiner. Capacity: up to 15 pounds (6.8 kg) dry wood chips per batch; less for .

    Get price
  • PULP TESTING EQUIPMENTS - Pfi Mill Type Lab Beater ...

    LABORATORY BEATER (PFI MILL TYPE) AS PER SCAN C 24 : 67, TAPPI T 248 CM 74, CPPA C.7, ISO 5264/2-1979; High Precision & Best Beater For Processing Pulp Prior To Information Of Hand Sheets, In Order To Determine The Behavior Of Pulp When Subject To Define Beating Schedule.

    Get price
  • PFI Laboratory Mill - Rycobel

    PFI Laboratory Mill ... the type of pulp). After having rotated the preselected revolutions, the roll and the housing stop and the refining process ends. Finally, the roll is situated in the centered initial position and the refined pulp is extracted to measure the freeness of the pulp ºSR or CSF.

    Get price
  • PFI Laboratory Mill | Rycobel

    The refining times vary from 2 to 10 minutes (depending on the type of pulp). After having rotated the preselected revolutions, the roll and the housing stop and the refining process ends. Finally, the roll is situated in the centered initial position and the refined pulp is extracted to measure the freeness of the pulp .

    Get price
  • Basic effects of pulp refining on fiber properties—A ...

    Jan 22, 2015· 3.1.1. Laboratory refiners. In the laboratory scale, PFI Mill, Valley Beater, Jokro mill and pilot-refiners are used for refining the small pulp samples where the mechanisms of refining are different. 3.1.1.1. PFI mill. As illustrated in Table 2, the PFI mill is the most commonly used laboratory

    Get price
  • Basic effects of pulp refining on fiber properties—A ...

    Jan 22, 2015· 3.1.1. Laboratory refiners. In the laboratory scale, PFI Mill, Valley Beater, Jokro mill and pilot-refiners are used for refining the small pulp samples where the mechanisms of refining are different. 3.1.1.1. PFI mill. As illustrated in Table 2, the PFI mill is the most commonly used laboratory

    Get price
  • Mechanisms of strength and stiffness improvement of paper ...

    CD Laboratory for Fiber Swelling and Paper Performance, Graz University of Technology, Inffeldgasse 23, ... depending on the pulp type and the refining equipment. Curl is known to have a direct ... Mechanisms of strength and stiffness improvement of paper after PFI refining with a focus on the effect of fines ...

    Get price
  • China Laboratory Pfi Beater - China Pfi Beater, Pfi Mill

    1. Specification: This PFI mill, PFI beater is vertical type, as one international standard laboratory equipment for pulp beating. This machine has the pulp-beating roller with some flying cutter, which run at the same direction of the smooth pulp beater chamber, but different rotary speed, with the help of beating pressure, to beat the pulp.

    Get price
  • RevSolution Sdn.Bhd. - Pulp and Sheet Making Testing

    Pulp and Sheet Making Testing. Adhesive and Label Testing. Coating Testing. Corrugated Testing. Film and Foil Testing. ... 72-15 Laboratory Pulp Refiner PFI-Type. Please contact [email protected] for technical specification. 73-18 Pulp Disintegrator.

    Get price
  • Refining of fibres at laboratory scale

    Laboratory Testing Refining of fibres at laboratory scale Refining of fibres at laboratory scale Mechanically converting the fibres to improve the paper properties To evaluate the potential for developing the mechanical properties of lignocellulosic fibres by doing a refining curve ... To produce a batch of refined pulp (chemical or mechanical ...

    Get price
  • Pulp and Paper Centre | Research Facilities Navigator

    Fibre and Pulp Quality Evaluation Lab Fibre quality analyzer and microscope, Sprout 50 HP 12'' Atmospheric High Consistency Refiner, 24 iter Repulper, Canadian Standard Freeness Tester, McNett Fractionation Tester, Sommerville Screener, disintegrators, handsheet maker, handsheet press, ovens, PFI mill, screw press

    Get price
  • Products | IDM Test

    Laboratory equipment for testing and quality control . ... IDM AUTOMATIC PFI TYPE LABORATORY MILL PULP. ... READ MORE. PILES VALEY TYPE REFILLER (DUTCH PILE) PTA PULP. Traditional Dutch pile type laboratory refiner. Used to refine a significant amount of paste/pulp 360 grams. READ MORE. PTA (8 INCH - 200MM) LABORATORY DISK REFINER ...

    Get price
  • LABORATORY BEATING OF PULP(PFI MILL METHOD)

    Laboratory beating of the pulp is a accepted method of simulating commercial refining practices. Laboratory-beaten pulps provide significant data that aid in determining ultimate performance of pulp when converted to paper. The PFI mill achieves this action by having the inner roll and outer casing rotate under constant load.

    Get price

About us

Founded in 1982, Dekelon Paper Making Machinery Co.,Ltd. has always striven to meet and exceed customer expectations and continue to update and improve...

Read More